Arctic Cat 1987 AFS El Tigre Service Manual page 74

•
B. Position the swing arm between the spider
bosses with a thrust washer on either side
of the arm. Press the pin into position leav-
ing enough room at either end of t he pin to
insta ll the new snap rings.
II NOTE: The thrust washers must be installed
with the metal side of the washer next to the
swing arm_
C. Apply LOCTITE
609
(or Perma-Lok HL
138)
to the threads of the set screw; then install
the set screw making sure the groove in
the pin is aligned with the set screw.
•
CAUTION
•
The groove in the pin must align with the set
screw.
Fig. 4·39
D.
Using a good snap-ring pliers, install the
new snap rings. Be sure the snap rings are
seated in the pin groove .
Fig. 4·40
E.
Slid e a metal bushing into each roller and
position a thrust washer on either s ide
with the bearing surface of the washer fac-
ing the roller. Insert the roller assembly
between the arm.
Fig. 4·41
021
F. Slide a weight onto the bolt; then push the
bolt w/weight through the roller arm and
roller assembly. Install the remaining
weight and self locking nut.
II
NOTE: The heads of the 3 bolts must all be
positioned from the right side of the roller
arm_ If this isn't done, the clutch will be out of
balance.
G. Tighten the lock nut to 0.4-0.5 kg-m (35·45
in.-Ib). Apply LOCTITE LOCK N' SEAL to
the threads of the bolt before installing
nut. Perform steps B-G to the remaining
two roller assemblies.
Fig. 4·42
5
4. Slide the spider assembly onto the hex shaft
with the split ring retainers directed up. Make
sure lines made during disassembly are align-
ed.
71