Arctic Cat 1987 AFS El Tigre Service Manual page 54

1. Install the throttle stop screw and spring.
8351
2. Install the pi lot air screw and sprin g. Turn
clockwise until lightly seated; then back out
1 V2 turns for an init ial setting.
Fig. 3·18
•
CAUTION
•
DO NOT force the pilot air screw when seating.
Forcing the screw will result in damage to the
carburetor body.
3. Install the pilot jet.
Fig. 3·19
8350
8352
4. A. Insert the needle jet into position from the
top of the carburetor making sure the
groove in the needle jet is ali gned with the
pin in the mixing body; then place the
main jet and washer into position and
secure.
B. Insert the needle jet into position from the
top of the carburetor making sure the
groove in the need le jet is ali gned with the
pin in the mixing body; then place the
screw guide into position and secure and
main jet into position and secure.
Fig. 3·20
8349
Fig. 3·21
8348
5. A. Place the seat and washer into position
and secure; then install the inlet needle
va lve.
B. In order, place a washer, plate, washer,
and seat into position and secure. Install
the inlet need le valve and secure with the
retai ner.
Fig. 3·22
8347
51
Il