Installing Engine/Transmission - Arctic Cat 700 DIESEL 2015 Service Manual

30. Install the coolant bypass hose and secure with the
support clamps and two Allen-head cap screws to the
two hollow studs; then secure the bypass hose to the
fittings with the hose clamps. Tighten securely.
31. Install a new crankshaft seal in the rear engine seal
flange; then apply a small amount of RTV Silicone to
the extended ends of the lateral seals.
32. Apply a liberal coat of oil-soluble grease to the lips
of the oil seal and using a new gasket, carefully
install the seal/flange assembly over the crankshaft
being careful not to nick or cut the seal lips.
33. Secure with the existing hardware and tighten to 9 ft-
lb.
98
DE442A
34. The engine is now assembled and ready for connec-
tion to the transmission/secondary transmission.
35. Install the engine/transmission assembly (see Install-
ing Engine/Transmission in this section).
Installing Engine/
Transmission
 NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the ATV.
 NOTE: If the engine/transmission was removed as
an assembly, proceed to Engine/Transmission in this
sub-section. If only the transmission was removed,
use the following procedure to install.
TRANSMISSION
1. If the V-belt housing was removed from the crank-
case, support the engine on blocks and using a new
DE497A
gasket, install the V-belt housing and tighten the
mounting cap screws to 25 ft-lb.
2. Using a new gasket, install the transmission into the
V-belt housing and secure with five cap screws. Do
DE502
not tighten at this time.
DE496
DE114A