Installing Toolbox And Taillight; Removing Rear Bumper, End Plate; Cap, And Snowflap; Installing Rear Bumper, End Plate, Cap, And Snowflap - Arctic Cat 1987 AFS El Tigre Service Manual

)
INSTALLING TOOLBOX AND TAILLIGHT
1. Install the bulb; then install the gasket and
lens and secure with two metal screws .
2. Connect the w iring harness; then rivet the
ground wire to the tunnel.
3. Rivet the toolbox shroud to the tunnel; then
secure the taillight assembly to the toolbox
with two metal screws.
4. Install the too lbox pad.
5. Install the seat cush ion.
REMOVING REAR BUMPER, END PLATE, CAP,
AN D SNOWFLAP
1. Remove the seat cushion; the n remove the
reflectors and bumper tape. Remove the four
machine screws and lock nuts securing rear
bumper and bumper reinforcements to the
t un nel. Remove the rear bumper and bumper
reinforcements .
2. Remove the end caps.
3. Remove the three carriage bolts and lock nuts
securing snowflap and cap; then remove cap
and snowf lap.
4. Chisel or drill out the rivets securing end plate
to the tunnel; then remove plate.
INSTALLING REAR BUMPER, END PLATE, CAP,
AND SNOWFLAP
1. Place end plate into position and secure with
rivets.
2. Place snowf lap and cap into position and
secure with thre e carriage bolts and loc k
nuts.
3. I nstall the end caps.
4. Place the rea r. bumper and bumper reinforce-
ments into position; then secure with the four
machine screws and lock nuts. Install the
seat c us hio n, bumper tape, and ref lectors.
REMOVING BELLY PAN, HOOD,
AND FRONT BUMPER
1. Remove the hood cable. Remove either the
expansion chambers or pulse charger; then
on the EI Tigre 6000 and Cheetah UC remove
the machine screws, washers, and lock nuts
securing the muffler to the belly pan.
2. Disconnect the headlight harness, remove
the bolts and lock nuts securing the hood
hinge to the belly pan hi nge, and slide hood
free of belly pan hinge. Account for two
washers and bushings.
3. Remove the machine screws and lock nuts
securing bumpers to the belly pan; then
remove bumpers. Account for washers, end
caps, and hood channels.
4. Position a support stand under the front end
assemb ly taking all pressure off the skis.
5. Drain the coolant f ro m the cooling system.
6. Remove the seat from the tunnel.
7. Remove the console. Remove the fuel line,
vent line, and spring securing the rear of the
fue l tank. Remove the tank.
Fig. 6·48
8361
8. Remove the sway bar arms and sway bar (see
Removing Sway Bar section).
Fig. 6·49
057
133