Arctic Cat 1987 AFS El Tigre Service Manual page 13

9. B. Loosen the clamp securing the hose to the
water-intake manifold; then remove the
hose allowing the coolant to drain into a
clean conta i ner.
10. B. Loosen the clamp securing the hose to the
thermostat cap; then loosen the clamp
securing the supply hose to the heat-
exchanger end cap. Remove the two
hoses from their fittings.
8297
11. B. Remove the temperature-gauge sender
from
the thermostat housing. While
loosening the sender uni t nut, secure the
sender unit adaptor nut to prevent it from
turning. If the adaptor is allowed to turn,
the temperature gauge wi ll be ruined .
10
8298
12. Remove the two cap-lock screws securing th e
rear of the engine plate to the front end. Ac-
count for two female mounts and cup
washers.
13. Remove the two cap-lock screws securing the
engine support to the front end . Account for
two female mounts and cup washers.
8299
III
NOTE: Remove the hood cable.
14. Lift the engine w/plate assembly out of the
engine compartment.
15. Remove the four bolts and lock washers
securing the plate assembly to the engine;
then separate engine and plate assembly.