Disassembling Carburetor - Arctic Cat 1987 AFS El Tigre Service Manual

r
Disassembling
Carburetor
II
NOTE: Procedures designated "A" are for
the Cougar, Cheetah FIC, EI Tigre 5000, and
Pantera; procedures designated "8" are for the EI
Tigre 6000 and Cheetah UC.
1. A. Remove the four screws and lock washers
secur ing the float chamber; then remove
8340
the float chamber and gasket.
3. Remove the brass choke-cab le ho usi ng from
the carburetor. Account fo r a washer.
Fig. 3-3
8341
4. Disconnect the fuel hose from the carburetor
inlet fitting.
5. Loosen the carburetor-f lange clamp; then
remove carburetor.
Fig. 3-4
8342
II
NOTE: Slide the carburetor into the boot
until free of the flange; then remove car·
buretor.
B. Remove the four screws and lock washers
secur ing the f loat chamber; the n remove
the float chamber and gasket. Remove the
ve nt hoses. Account for the hose plates.
Fig. 3-5
8343
2. Remove the caps from the float towers; then
remove the floats. Remove the drain plug and
washer (O·ring on the Cougar, Cheetah
FIC,
EI Tigre 5000, and Pantera).
Fig. 3·6
8344
II
NOTE: The floats should be removed only if
replacement is necessary.
47