Arctic Cat 1987 AFS El Tigre Service Manual page 16

Fig. 2·18
030
III NOTE: To ensure the cleanliness of the fly·
wheel magnets, place the flywheel (with the
magnets facing upward) on a clean bench.
13. Scribe a line on the stator plate and
crankcase to aid in assembly; then remove
the two screws, lock washers, and washers
securing the stator plate to the crankcase.
III NOTE: The two stator plate screws have had
LOCTITE applied to the threads during
assembly. Before removing them, apply a sharp
blow to the head of each screw to break the LOC·
TITE
loose. If this isn't done, the screws can
be
very difficult to remove.
Fig. 2·20
032
14. Loosen the screw that secures the wire reo
tainer bracket. Remove the wiring grommet
from the magneto case and remove the stator
plate from the engine.
033
15. Us ing an impact screwdriver, remove the
eight screws securing the magneto case to
the crankcase. Using a plast ic hammer, tap
on the backs ide of the magneto case to free it
from the crankcase.
Fig. 2·22
16. Remove the two bolts, lock washers, and
washers securing the oil-injection pump; then
remove the pump, retainer, shim, and gear.
Account for two gaskets.
13
EJ