Arctic Cat 1987 AFS El Tigre Service Manual page 144

Fig. 7·5
•
CAUTION
•
Be sure to use either a rubber hammer or a piece
of wood to remove wear strips from rails. If a
steel hammer or punch is used, the rails may be
nicked and damaged.
064
4. Remove cap-lock screws and washers secur-
ing rear idler wheels to rear axle.
~:
.7·6
065
5. Sli de the rear idler wheels and spacer
washers off the rear axle.
6. Remove the rear axle from the axle housing.
Account for washers, spacers, and center
idler wheel.
Fig. 7·7
7. Remove the four bolts and two lock nuts
securing the axle housings; then slide the
housings off the rails.
Fig. 7·8
067
II
NOTE: Be sure to note the location of the
rear rail support when removing axle hous-
ings. Support must be located between the front
mounting holes.
8. Remove the two cap screws that secure the
rear arm to the slide rails. Slide the rear arm
off the back of the rai ls. Account for inner
shaft and bushings.
Fig. 7·9
068
141
D