Arctic Cat 1987 AFS El Tigre Service Manual page 95

10. Inst all the PTa-s ide bearing w/collar and
flange plates on the driven shaft; do not
tighten co llar at thi s time. Place the driven
shaft into position maki ng sure the brake disc
and fla nge plates are properly posit ioned.
Secure with PTa-s ide bearin g and flange
plates with t hree bo lts and lock nuts. Tig hten
and then to rque to 2.2-2.5 kg-m (16-18 ft- Ib).
II
NOTE: On the EI Tigre 6000 and Cheetah
LlC,
be sure to place the torque link into position
before installing the lock nuts_
8381
11. On the MAG-side driven shaft, app ly Scotch-
Bond Adhesive 4174 to the bearing seating
area adjacent to the shaft splines. Install the
bearing, sea l, and flange plate and secu re
with t hree lock nuts. Tighten to 2.2-2.5 kg-m
(16-18 ft- I b).
12. Loop the chai n around the lower sprocket and
sli de t he upper sprocket w/chain onto the
driven shaft. Secure upper sprocket wit h a
cap-lock screw (coated with LOCTITE LOCK
N' SEAL) and pyramidal-tooth washer.
Tighten both sprockets to 2.6-3.3 kg -m (19-24
ft-Ib). Drive the driven shaft bearin g col lar in
the direc t ion of rotation to loc k beari ng; then
t ighten set s crew .
Fig . 4·112
90
13. Slide the brake disc against the upper bea ring
of the cha in case; then s li de lock col lar
against brake hub and tighten the set screw
secure ly.
14. On the PTa side of the track driveshaft, slide
the lock col la r against the bearing, drive the
collar in the direct ion of rotat ion until tight,
and tighten the collar set screw.
Fig. 4·113
8477
15. I nstall t he sk id frame (see Track/Sus pen-
sion-Ins talling Sk id Frame sect ion).
16. Check ali gnment of the sprockets using the
following procedure:
a. Place a stra ightedge against the faces of
the sp rockets.
b. Using a feeler gauge, check fo r clearance
along th e faces of both sprocket s. If
c lea rance exceeds 0.8 mm (0.030 in.),
shimm ing is necessary.
Fig . 4·114
0.8 mm
(0.030 in.)
rlr
i
1-'
1- 1
;,
0725·171
II
NOTE: Sprockets can only be shimmed out.