Removing Movable Sheave Bushing - Arctic Cat 1987 AFS El Tigre Service Manual

Fig. 4·23
•
CAUTION
•
The pilot tool must be used to properly locate the
holes.
7. Using a 10·24 tap, tap the three new holes.
Fig. 4·24
8. Apply LOCTITE (red) to the threads of the
three set screws and install them into the
three newly threaded holes.
9. Using a small punch, stake the top of the
three holes to prevent the set screws from
backing out.
Fig. 4·25
Removing Movable Sheave Bushing
1. Using a 3/32 in. hex wrench, remove the three
set screws from the movable sheave.
2. Set the movable sheave upside down on top
of the sleeve support. The s leeve support
must be used to support the area around the
bush ing as the bushing is being either driven
or pressed out of the sheave.
Fig. 4·26
3. Using the hex shaft driver, drive or press the
hex bushing down and out.
67