Installing; Drive Clutch (Ei Tigre & Cheetah Uc); Removing; Disassembling - Arctic Cat 1987 AFS El Tigre Service Manual

INSTALLING
1. Place t he drive c lutch into positi on on the
cranks haft.
2. Install the bo lt and lock washer. Tighten the
bo lt to 7.6-8.3 kg-m (55-60 ft-Ib).
3. Check alignment between the drive clutch
and driven pulley.
4. Insta ll the drive belt and secure the clutch
shield .
5. Insta ll plug in t he be lly pan.
r
Drive Clutch
(EI Tigre-Cheetah L/C)
REMOVING
1. Open the c lutch shield and remove the drive
belt.
2. Remove the plug from the belly pan .
3. Remove the bolt and lock washer securing
the drive clutch to the crankshaft; then
remove the pilot washer.
4. Usi ng t he Com et Drive Clutch Puller and an
impact wrench (or a breaker bar and chain
wrench) , tighten the pu ller. If the drive clutch
will not re lease, sharply st rike the head of the
puller. Repea t step until c lutch releases.
III NOTE: Before installing the clutch puller,
apply oil to the threads of the puller and a
small amount of grease to the tip of the puller.
Fig. 4·51
B291
5. Remove the clutch from the engine compart-
ment.
DISASSEMBLING
1. Scribe a line across ali components.
2. USing an impac t wrench, loosen the six bolts
sec uri ng the cover plate. Remove every other
bolt and lock washer from the cover plate;
then while firmly holding the cover plate,
remove the three remaining bolts and lock
washers equa lly.
73