Arctic Cat 1987 AFS El Tigre Service Manual page 151

Fig. 7·34
15. Lock adju stmen t blocks secu rely in pos it ion .
Torque adjustme nt block bolt to 3.2 kg-m (23
ft- Ib).
Fig. 7·35
091
16. Slide center idler wheel axle into position.
Position washers and idler wheels on axle.
Secure wheels to axle using larger washer
and cap screws. Torque cap screws to 1.5 kg-
m
(11 ft-Ib).
Fig. 7·36
070
148
17. Assemb le rear arm by placing its axle and
bushings into the lower mounting crossbrace.
Position arm between slide rails and secure
with two bolts and lock washers. Torque bolts
to 3.2 kg-m (23 ft-Ib).
Fig. 7·37
068
18. Place ax le and bushin gs into the upper id ler
arm mounting tube and secure the upper arm
to the lower arm with a bolt and lock nut tor-
qued to 3.2 k-gm (23 ft- Ib). Assemble upper
idler shaft and wheels to tube along with
outer spacers and washers.
Fig. 7·38
092
19. Secure the rear ax le housing s to the ra il s us-
ing four bolts and two lock nuts. Align the rear
rail support with the forward mount in g bolts.
Place lock nu ts on the bolts. Torque bolts and
lock nuts to 1.5 kg-m (11 ft-Ib). Be sure that the
wide portion of the ax le bushings are posi-
tioned "out" on each ra i I.
(