Cleaning And Inspecting - Arctic Cat 1987 AFS El Tigre Service Manual

Fig. 5·15
8267
2. Remove the two long bolts and lock washers;
then loosen the terminal nut.
Fig. 5·16
8268
3. Remove the E·ring and washer securing the
armature shaft; then remove armature shaft
assemb ly and rear cove r.
Fig. 5-17
•
CAUTION
•
When removing the rear cover, make sure the
terminal stays with the yoke as it is connected to
the field magnets.
8269
4. Slide the stopper down the shaft, remove the
retaining ring, and remove the stopper and
spring.
5. Remove the pinion assembly and front cover.
Account for any washers.
Fig. 5·18
o
o
CLEANING AND INSPECTING
II NOTE: Whenever a part is worn excessively,
cracked, defective, or damaged in any way,
replacement is necessary.
1. Thoroughly clean all components with a
clean cloth and compressed air.
2. Inspect al l threaded areas for damaged or
stripped threads .
3. Inspect the brush holder assemb ly and brush·
es for damage or wear.
II
NOTE: Using a caliper, measure the length of
the brushes. If any brush measurement is
less than 7.5 mm (0.30 in.), replacement is
necessary.
109