Arctic Cat 1987 AFS El Tigre Service Manual page 32

Fig. 2·83
22. Position the wiring harness clamp over wiring
harness and secure with screw. Install grom-
met.
Fig. 2·84
033
23. Install the flywheel key in the crankshaft
keyway and slide the flywheel onto the crank-
shaft mak ing sure the keyways match. Install
t he flat washer, lock washe r, and flywheel
nut. Apply LOCT ITE LOCK N' SEAL to the
crankshaft threads before instal li ng the nut.
24 . Place the fan housing into position and
secure with five nuts. Torque the six nuts to
1.5-1.9 kg-m (11-14 ft-Ib).
25. Temporari ly install the starte r pulley on the
flywheel with three bolts. Us ing a spanner
wrench to secure the flywheel , torque the fly-
wheel nut to 9.0-11 .0 kg-m (65-79 ft-Ib).
Fig. 2·86
047
26. Install an intake gasket lightly coated with
silicone sealer on each cylinder. Install an ex-
haust gasket on each cylinder with its meta l
side positioned towards the cy li nder exhaust
f lange . Install the cooling shrouds and secure
wi t h 15 screws, lock washers, and washers.
27. Instal l the outer intake gasket, coated lightly
w ith si licone sealer on each cy li nder next to
the cooling shroud. Slide the gaskets, in-
sulator blocks, and carburetor flanges into
posit ion on eac h cylinder. Secure with nuts
and washers. Torque the four nuts to 1.8-2.2
kg -m (13-16 ft- Ib) using a crisscross pattern.
28. Slide the two oil -injection hoses onto the fit-
t ings on the insu lator blocks. Be certa in all
hose clamps are in place; then tighten the
screw clamps.
Fig. 2·87
29
EJ