Installing - Arctic Cat 1987 AFS El Tigre Service Manual

6. Carefully s li de the reco il over hub and engage
the sp ring with the roller.
7. In sta ll the pawl spring making sure the end is
properly insta ll ed in th e hole in th e reco il
ro ll er; then in sta ll the paw l making sure the
paw l spri 9 is properly pre loaded.
Fig. 8·6
8525
8. Sli de end of reco il rope th ro ugh rope gu ide of
t he case; then tie a sl ipknot in the recoi l rope.
9. Place th e sp ring clip into posi ti on on the drive
plate making sure t he head of t he c lip is op-
pos ite th e flat of the inner hole. Apply a low-
tempe ratu re grease to the drive plate.
Fig. 8·7
8524
10. Place th e drive plate into pos it ion making
sure the fla t of th e inne r hole is cor rec t ly pos i-
tioned in the hub; t hen secure drive plate with
washer a nd nut. Tighten to 1.0 kg-m (7 ft-Ib).
II
NOTE: Apply LOCTITE LOCK N' SEAL (red)
to the threads before installing.
166
Fig.S·S
8526
11. With about V2 m (20 in.) of rope exposed, hook
the rope in the notc h of the recoil rol ler.
12. Rotate the reco il roller four or five turns
counterclockw ise; then release the recoil
rope from t he notch and allow the rope to
retrac t.
13. Pull reco il rope out two or three t imes to
check fo r correct tension .
II
NOTE: Increasing the rotations in step 12
will increase spring tension; decreasing the
rotations will decrease spring tension.
[~
______ I_n_s_ta_I_I_in_g ______
~)
1. Place rec oi l assemb ly into position again st
th e magneto case.
2. Sec ure recoil with four bo lts and lock wash-
ers. Tighten to 0.7 kg-m (5 ft-Ib) .
II NOTE: Before tightening the bolts, slowly
pull recoil rope until the pawl engages; then
tighten bolts. This will center the recoil on the
magneto case.
3. Thread reco il rope t hrough recoi l bush ing in
th e conso le and insta ll th e hand le. Secure
wit h a knot.
4. Release the slipknot in t he rop e.
(
)