Arctic Cat 1987 AFS El Tigre Service Manual page 90

Fig. 4·101
13. Continue to s lide the dr iven shaft until it is
out of the PTO side. Account for a bearing ,
two flange plates, and the PTO-side driven-
shaft co llar.
14. Remove the skid frame from the tunnel (see
Track/Suspension - Removing Sk id Frame
sect ion).
15. Rem ove t he t hree PTO-s ide lock nuts and
bolts securing the drives haft-bea ring f lange
pl ates and dri ve adaptor. Remove dri ve adap-
to r and cab le.
B09 0
Fig. 4·103
10. Loosen the set sc rew on t he PTO-side driven-
shaft colla r. Dri ve the co llar clockwise (op-
posite shaft rotation) until it is free.
II
NOTE: A fine file should be used to remove
any burrs left by the collar set screw.
11. Remove the three lock nu ts and bolts secu r-
ing the PTO-s ide driv en shaft flange plates.
Account for t he t orq ue link on t he EI Tigre
6000 and Cheet ah UC.
II
NOTE: It may be necessary to remove the
PTO·side carb uretor for thi s procedure. Also,
it is necessary to use an extens ion and universa l
joint to remove the rear lock nut from upper flange
plate.
Fig. 4·102
B381
12. Force the driven shaft toward the PTO side
(rotating the shaft to prevent the brake disc
from b i nding on the shaft) until brake disc is
free. Account for the key. Remove the loc k
collar pos itioned next to the brake disc from
the shaft.
II NOTE: A fine file should be used to remove
any burrs left by the collar set screw.
B475
16. Tap the driveshaft toward the chain case to
unseat MAG-side bearing. Remove bearing.
17. Slide the driveshaft toward the MAG side until
the PTO end of the driveshaft is out of its
mounting ho le. Tilt the end of the dr iveshaft
away from the tu nne l and slide t he drivesha ft
free of the tunnel. Remove track.
Fig. 4·104
B096
18. Scribe a line on the driveshaft along the edge
of each sprocket to aid in assemb ly. Loosen
the set sc rew on the collar, drive the co llar
clockwise unti l free, and remove the bearing
and f lange plates from the drives haft.
87