Return To The Factory Settings - DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual

5. Commissioning
4"
0 2 4 6 8
E 1
2
MODE
1
D
2
bar
# F
% $
AUTO
J I
+ +
C002296-B-04
Menu #RESET
Choice of generator Parameter
GENERATOR RESET TOTAL
0 2 4 6 8 10 12 14
LANGUE
Français - Deutsch - English -
E 1
Italiano - Espanol - Nederlands
2 - Pycck - Polski - Türk -
1
D
2
bar
# F !

% $
J I
STD
112
10 12 14 16 18 20 22 24
SUNDAY 11:45
 !
:
<
STD
EXCEPT PROG. Performs a parameter RESET but retains the timer programmes
PROG.
SENSOR SCU
ROOM SENSOR Performs a RESET of the room sensors connected
16 18 20 22 24
FRANCAIS
C002286-C
4. The screen displayed is used to select the numbers of the slave
VMs to be removed from the network. Turn the rotary button to
scroll through the numbers and press to remove the number
chosen. Press j to go back to the previous list.
5. Select NB.NETWORK ELEMENTS. This screen summarises the
elements in the network recognized by the system. Press j to go
back to the previous list.
5.7.5.

Return to the factory settings

To reset the appliance, proceed as follows:
1. Press key C , > and j simultaneously for 4 seconds. The menu
#RESET is displayed.
2. Set the following parameters:
Description
Performs a TOTAL RESET of all parameters
Performs a RESET on the timer programmes but retains the parameters
Performs a RESET of the generator sensors connected
After reset (TOTAL RESET and RESET EXCEPT PROG.), the
control system goes back to the display of the language choice after
a few seconds.
1. Select the desired language by turning the rotary button.
2. To confirm, press the rotary button.
AWHP-2 MIT-IN-2 iSystem
25/06/2014 - 7616371-001-04