DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual page 129

AWHP-2 MIT-IN-2 iSystem
After Sales level - Menu #TEST OUTPUTS
Parameter Adjustment range Description
P.CIRC.A ON / NO
(1)
ON / NO
P.CIRC.B
(1)
ON / NO
P.CIRC.C
(1)
ON / NO
SOLAR P.
AUX.CIRC. ON / NO
(1)
ON / NO
HW.PUMP
(1)
REST
3WV B
OPEN:
CLOSE:
(1)
REST
3WV C
OPEN:
CLOSE:
TEL.OUTPUT ON / NO
PUMP HP ON / NO
PUMP MIT/MHR ON / NO
STAGE 1 ON / NO
STAGE 2 ON / NO
DHW BACKUP ON / NO
RV ON / NO
(1) The parameter is only displayed for the options, circuits or sensors actually connected
After Sales level - Menu #TEST INPUTS
Parameter Status
PHONE REM.
FAILURE ON
OFF
SEQUENCE
TYPE
STOP / GO Status of the PAC pump
P HP
(1)
ON
R.CTRL A
OFF
(1)
ON
R.CTRL B
OFF
(1)
ON
R.CTRL C
OFF
(1) The parameter is only displayed for the options, circuits or sensors actually connected
After Sales level - Menu #CONFIGURATION
Parameter Adjustment range Description
MONO/ ALL.CIRC To chose if the exemption made for one remote control applies to a single circuit
MODE:
TYPE
(1)
DFDU
AUTODETECTION
TAS OFF/ON
(1) The parameter is only displayed if INSTALLATION is set to EXTENDED
25/06/2014 - 7616371-001-04
Stop/start pump circuit A
Stop/start pump circuit B
Stop/start pump circuit C
Solar pump On/Off
On/Off auxiliary outlet
Stop/start domestic hot water pump
No command
Opening 3-way valve circuit B
Closure 3-way valve circuit B
No command
Opening 3-way valve circuit C
Closure 3-way valve circuit C
On/Off telephone relay outlet
HP pump ON/OFF
ON/OFF MIT pump
ON/OFF back-up stage 1
ON/OFF back-up stage 2
ON/OFF DHW back-up
Reversal valve command on the PCU PCB
Description
Bridge on telephone input (1 = presence, 0 = absence)
Fault display
No fault
Control system sequence
Type of heat pump
Presence of a remote control A
No remote control A
Presence of a remote control B
No remote control B
Presence of a remote control C
No remote control C
(MONO) or if it must be transmitted to a group of circuits (ALL.CIRC)
Generator type (HP)
Generator type
Detection of SCU boards connected to the PCU board
Activation of the Titan Active System® function
8. Troubleshooting
127