Installing The Outside Sensor; Choice Of The Location; Connecting The Outside Sensor - DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual

AWHP-2 MIT-IN-2 iSystem
4.6

Installing the outside sensor

25/06/2014 - 7616371-001-04
4.6.1.
It is important to select a place that allows the sensor to measure the
outside conditions correctly and effectively.
Advised positions:
4 on one face of the area to be heated, on the north if possible
4 half way up the wall in the room to be heated
4 under the influence of meteorological variations
4 protected from direct sunlight
4 easy to access
Recommended position
A
Possible position
B
Inhabited height controlled by the sensor
H
Inhabited area controlled by the sensor
Z
8800N001-C
Positions to be avoided:
4 masked by a building element (balcony, roof, etc.)
4 close to a disruptive heat source (sun, chimney, ventilation grid,
etc.)
8800N002-C
4.6.2.
Mount the sensor using the screws and dowels provided.

Choice of the location

Connecting the outside sensor

4. Installation
29