Putting The Appliance Into Operation - DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual

AWHP-2 MIT-IN-2 iSystem
5.4

Putting the appliance into operation

C002366-B
0 2 4 6 8 10 12 14
LANGUE
Français - Deutsch - English -
E 1
Italiano - Espanol - Nederlands
2 - Pycck - Polski - Türk -
1
D
2
bar
# F !

% $
J I
STD
25/06/2014 - 7616371-001-04
MW-M001832-2
16 18 20 22 24
FRANCAIS
C002286-C
1. Make a note of the output and type shown on the outside module's
nameplate.
2. Switch on the power by throwing the on/off switch on the inside
module.
3. The first time the boiler is powered up, the LANGUAGE menu is
displayed. Select the desired language by turning the rotary
button.
4. To confirm, press the rotary button.
5. The parameter TYPE displays. According to the values noted on
the outside module's nameplate, select the type of thermodynamic
unit by turning the rotary button.
Outside module output Indoor module TYPE
From 4 to 16 kW
22 and 27 kW
Error during the start-up procedure:
4 No information is shown on the display:
- Check the mains supply voltage.
- Check the fuse (¼See chapter: "Location of the fuse", page
47).
- Check the connection of the power cable to the connector on
the PCU PCB (See chapter: ¼ "Connecting the mains
supply to the inside module", page 49).
4 If there is a problem, the error is displayed on the screen.
¼See chapter: "Messages", page 118.
MIT-IN-2/E
MIT AWHP E HT FR
MIT-IN-2/H
MIT AWHP H HT FR
MIT-IN-2/E
MIT AWHP E FR
MIT-IN-2/H
MIT AWHP H FR
5. Commissioning
83