Checks And Adjustments After Commissioning; Displaying The Parameters In Extended Mode; Setting The Heating Pump Speed On The Heat Pump - DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual

5. Commissioning
5.5

Checks and adjustments after commissioning

0 2 4 6 8
E 1
TEMP.: 68°
2
1
D
2
F
#
% $
AUTO
J I
5"
Installer level - Menu #SYSTEM
Parameter Adjustment range Description
INSTALLATION TRADITIONAL
EXTENDED
0 2 4 6 8
E 1
TEMP.: 68°
2
1
D
2
F
#
% $
AUTO
J I
5"
84
10 12 14 16 18 20 22 24
SUNDAY 11:45
 ! :
<
STD
C002235-F-04
Displays the parameters of a conventional
installation
Displays all parameters
10 12 14 16 18 20 22 24
SUNDAY 11:45
 ! :
<
STD
C002235-F-04
5.5.1. Displaying the parameters in extended
mode
The display mode on the control panel is set as standard in such a
way as only to show the conventional parameters. It is possible to
switch to extended mode by proceeding as follows:
1. Access the installer level: Press key - for around 5 seconds.
2. Select the menu #SYSTEM.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 80
3. Set parameter INSTALLATION to EXTENDED.
Regardless of what is done to the keys, the regulator
switches back to TRADITIONAL mode after 30 minutes.
5.5.2. Setting the heating pump speed on the heat
pump
The setting is used to select the speed of the primary pump located
between the condenser and the tank, according to the output of the
outside module; it is important to guarantee correct running of the heat
pump.
1. Access the installer level: Press key - for around 5 seconds.
2. Select the menu #PRIMARY LIMITS:
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 80.
AWHP-2 MIT-IN-2 iSystem
Factory setting Customer setting
TRADITIONAL
25/06/2014 - 7616371-001-04