DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual page 68

4. Installation
Settings to be made for this type of installation
Parameters Access
Installer level
INSTALLATION
#SYSTEM menu
(1) Installer level
FLOWM.LOC.
Menu #ENERGY
COUNTERS
Installer level
(1)
GLYCOL
Menu #ENERGY
COUNTERS
(1) Installer level
ELEC.PUL.VAL.1
Menu #ENERGY
COUNTERS
Installer level
(1)
ELEC.PUL.VAL.2
Menu #ENERGY
COUNTERS
Installer level
(1)
BACKUP 1
Menu #ENERGY
COUNTERS
Installer level
(1)
BACKUP 2
Menu #ENERGY
COUNTERS
Installer level
(1)
DHW RESISTOR
Menu #ENERGY
COUNTERS
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED
66
CAUTION
Do not install meters for the electric back-ups. The power
input when setting the parameters is used to automaticaly
calculate the consumed and restored energy.
Settings to be made
EXTENDED
PCU 194
0%
According to the specifications of the
electricity meter
According to the specifications of the
electricity meter
According to the stage 1 output
configuraton on the electrical back-ups
¼ "Connecting the electrical
back-up to the inside module", page
49
According to the stage 2 output
configuraton on the electrical back-ups
¼ "Connecting the electrical
back-up to the inside module", page
49
According to the electrical resistor output
of the DHW tank
Examples of settings:
Metering the energy of the heat pump only: Set parameters BACKUP
1 and BACKUP 2 to 0. Set parameter DHW RESISTOR to 0.
Metering the energy of the heat pump and the back-ups: Set
parameters BACKUP 1 and BACKUP 2 according to the output
configuration of the stages of the electrical back-ups (¼
"Connecting the electrical back-up to the inside module", page 49).
Set parameter DHW RESISTOR according to the electrical output of
the DHW tank.
AWHP-2 MIT-IN-2 iSystem
See chapter
¼ "Displaying the
parameters in extended mode",
page 84
¼ "Professional settings",
page 98
25/06/2014 - 7616371-001-04