Setting The Speed Of The Heating Pump On The Inside Module; Reading Out Measured Values - DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual

5. Commissioning
0 2 4 6 8
E 1
TEMP.: 68°
2
1
D
2
# F
% $
AUTO
J I
5"
Installer level - Menu #PRIMARY LIMITS
Parameter
(1)
PERCENT PUMP MIT
(1) The menu is displayed only if the INSTALLATION parameter is set to EXTENDED
5.6

Reading out measured values

0 2 4 6 8
E 1
2
1
D
2
bar
# F 
% $
AUTO
J I
STD
94
10 12 14 16 18 20 22 24
SUNDAY 11:45
!
 :
<
STD
C002235-F-04
Adjustment range Description
1 - 5 Inside module pump speed 3
10 12 14 16 18 20 22 24
SUNDAY 11:45
!
:
<
C002219-D-04
5.5.7. Setting the speed of the heating pump on
the inside module
The setting is used to select the speed of heating pump A, located on
the secondary tank circuit. The speed must be selected in such a way
as to have a temperature differential between the flow and the return
of 5 to 10 K when running at nominal output.
1. Access the installer level: Press key - for around 5 seconds.
2. Select the menu #PRIMARY LIMITS:
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 80.
Factory setting Customer setting
CAUTION
The integrated filter must be cleaned after one hour's
operation on commissioning.
¼ "Cleaning the 400 µm filter", page 114.
The various values measured by the appliance are displayed in the
#MEASURES menu.
1. To access user level: Press the > key.
2. Select the menu #MEASURES.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 80.
AWHP-2 MIT-IN-2 iSystem
25/06/2014 - 7616371-001-04