Customising Maintenance; Maintenance Message - DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual

AWHP-2 MIT-IN-2 iSystem
Outside module output Speed of the heat pump heating pump Nominal water flow Minimum flow rate
4, 6 kW
8 kW
11 kW
16 kW
22, 27 kW
2
3
7.4

Customising maintenance

0 2 4 6 8
E 1
TEMP.: _ _ _ _
2
1
D
2
bar
# F
% $
AUTO
J I
10 "
25/06/2014 - 7616371-001-04
1
2
2
4
5
1
M002646-A
4
M002647-A
10 12 14 16 18 20 22 24
SUNDAY 11:45
 !
:
<
STD
C002272-C-04
l/min
22
26
29
38
41
1. Close the valve on the exchanger.
2. Unscrew the cover.
3. Dismantle the spring retaining ring.
4. Dismantle the filter.
5. Check and clean the filter.
Replace the filter if necessary.
6. Remount the filter.
7. Tighten the connection.
8. Open the valve on the exchanger.
7.4.1.

Maintenance message

The heating generator includes a function used to display a
maintenance message. To set the parameters for this function,
proceed as follows:
1. Access the "After Sales" level: Hold down the - key until
#PARAMETERS is displayed.
2. Select the menu #REVISION.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 80
3. Set the following parameters:
7. Checking and maintenance
recommended
l/min
12
16
19
28
35
115