DeDietrich AWHP-2 MIT-IN-2 iSystem Installation And Service Manual page 72

4. Installation
Settings to be made for this type of installation
Parameters Access
Installer level
INSTALLATION
#SYSTEM menu
Installer level
(1)
CIRC.A
#SYSTEM menu
Installer level
PUMP MIT/MHR
#SYSTEM menu
Installer level
(1)
CIRC.B
#SYSTEM menu
Installer level
CT.TEL
#SYSTEM menu
Installer level
I.TEL
#SYSTEM menu
Installer level
DHW TYPE
#PRIMARY INSTAL.P menu
Installer level
BACKUP TYPE
#PRIMARY INSTAL.P menu
Installer level
HP BUS
#PRIMARY INSTAL.P menu
Installer level
CIRC.CURVE A
#SECONDARY INSTAL.P
menu
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED
70
Connect the DHW tank anode.
I
CAUTION
4
4
Not used: Do not connect anything to the terminal block.
O
Connect the motor on the DHW reversal valve.
P
Connect the EVU contact to the 1-2 terminals on the
a
TEL connector.
Connect the BUS cable between the outside module and
z
the terminal block on the inside module.
¼ "Connecting the communication cable between the
inside and outside modules", page 47.
Inside module with electrical back-up
e
Outdoor unit
r
Buffer tank
t
Settings to be made
EXTENDED
DIRECT
CIRC.A
3WV
CLOSE
0/1 EVU
SECONDARY
/E1: Stage 1
/E2: Stage 2
TOR
0.7
AWHP-2 MIT-IN-2 iSystem
If the tank is fitted with a Titan Active
System® impressed current anode,
connect the anode to the inlet (+ TA on the
anode, - on the tank).
If the tank is not fitted with an impressed
current anode, put the simulation
connector in place (delivered with the DHW
sensor - package AD212).
See chapter
¼ "Displaying the parameters in
extended mode", page 84
¼ "Setting the parameters specific to
the installation", page 86
¼ "Setting the parameters specific to
the installation", page 86
¼ "Setting the parameters specific to
the installation", page 86
¼ "Setting the parameters specific to
the installation", page 86
¼ "Setting the parameters specific to
the installation", page 86
¼ "Professional settings", page
98
¼ "Professional settings", page
98
¼ "Professional settings", page
98
¼ "Professional settings", page
98
25/06/2014 - 7616371-001-04