Control Panel; Rep 2.1 Control Panel Assembly - Xerox Document Workcenter 150 Service Manual

REP 2.1 Control Panel Assembly k,
Parts List on PL 2.1
Removal
WARNING
Disconnect the Power Cord from the
outlet.
1. Remove Front Cover (REP 1.1).
2.
Remove the Control Panel (Figure 1).
a. Open the Control Panel.
CAUTION
The flexible fab on the right side pivot w;//
break if overllexed.
b. Slide the Control Panel to the right.
c. Slide the Control Panel off of the left
pivot.
d. Slide the Control Panel off of the right
pivot.
3. Disconnect the cable connector.
Replacement
1. Reinstall the components in the reverse order.
Figure I
Removing the Control Panel Assembly
5/96
Document WorkCenter 150
4-5
REP
2.1 Control Panel Assembly