End Point - FUTABA T10J Manual

End point

END POINT
Function
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
●The servo travel can be adjusted individually at
the left and right sides.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
● Select the channel with
the Jog key.
＜ ChannelDisplay ＞
ACROBATIC
1: AIL （ Aileron） 6: FLP （ Flap）1: AIL （ Aileron） 6: PIT （ PITCH）1: AIL （ Aileron） 6: FL2 （ Flap2） 1: AIL （ Aileron） 6: AUX
2: ELE （ Elevator）7: AUX
3: THR （ Throttle）8: AUX
4: RUD （Rudder）9: AUX
5: GER （ Gear） 10: AUX
End point
① A channel is chosen by Jog key.
Selection range：1 〜 10ch
Adjust the rate of each direction of the stick and VR by repeating step ① .
50
"END POINT"
② Select
from the menu with the Jog
key.
END POINT
→ 1: AIL
2: ELE
CH1 : AIL 3: THR
4: RUD
← →
5: GER
100 100
（Left ／ Down） （Right ／ Up）
rate display rate display
HELICOPTER
2: ELE （ Elevator）7: AUX
3: THR （ Throttle）8: AUX
4: RUD （Rudder）9: AUX
5: GYR （ GYRO） 10: AUX
② Operate the stick or knob of the selected
channel fully to the left (down) or right (up)
and adjust the rate by pressing the + key or
– key.
＋
Servo throw
At 100% setting the servo throw of each channel is about 40°
for channels 1 to 4 and about 55° for channels 5 to 10.
However, the maximum servo travel for channels 5 to 10 is
about 110%.
*When channels 5 to 8 were mixed by flaperon, differential or
ailvator, the throw becomes the same (about 40° ) as channels
1 to 4.
③ Open the setting screen by
pressing the Jog key.
1 2
100 /100
100 /100
● T h e s e t t i n g r a t e o f e a c h
100 /100
100 /100
100 /100
GLIDER (AF4)
2: ELE （ Elevator）7: AL2 （ Aileron2）2: ELE （ Elevator）7: AUX
3: MOT （ Motor） 8: FL3 （ Flap3） 3: THR （ Throttle）8: AUX
4: RUD （Rudder）9: FL4 （ Flap4） 4: RUD （Rudder）9: AUX
5: FLP （ Flap） 10: AUX
－
or
(Common)
channel
MULTICOPTER
5: MOD 10: AUX
Range：
0 〜 140%
Default：100%
● When you want to
return the set value
to the initial value,
press the + key and –
key simultaneously.