Selection Of Installation Location - Canon NP-1015 Service Manual

I. SELECTION OF INSTALLATION
LOCATION
The copier should be installed in a
location that meets the following require-
ments. It is recommended that the service
technician personally inspect the cus-
tomer's premises before installing the
copier.
A. The location should have an electric
B.
C
outlet capable of supplying the voltage
shown on the rating plate (& 10%) and
a current of at least 15A. The copier
must be grounded. (AB-pin plug must be
used.)
The ambient temoerature should be
within the range 7.5 to 32.5"C (45 to
90°F) and the relative humiditv between
10 and 85%. The copier should not be
installed near water faucets, space
heaters, humidifiers, or refrigerators.
The copier should not be installed close
to a naked flame or in a dustv area. or
where it will be exposed to ammonia
fumes or direct sunlight. If it must un-
avoidably be installed beside a sunlit
window, place protective curtains
across the window to block the light.
D. The room should be well ventilated.
E. Make sure that the copier is installed on
a level surface with all of its feet in
contact with the floor.
F. The rear of the copier should be at least
1OOmm (4") away from the wall, with
enough space at the ends to permit
unrestricted operation.
COPYAIGHT 0 1988 CANON INC
2m min _
(78.7"l
Figure 5-1
L 2.5m mir -
(98.4")
Figure 5-2 Copier with sorter installed
CANON HP-1015/1215S AN.0 OCT. 1988 PAINTEO IN JAPAN IlMPRlMf AU JAPONI
5-l