Removing And Installing Parking Brake Switch; Removing And Installing Brake Pressure Sender G201 - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
Brake system - Edition 03.2013
5.4 Removing and installing parking brake
switch
Removing
– Remove extension of centre console ⇒ Rep. gr. 68 ; General
body repairs, interior .
– Remove switch -item 2- from navigation unit.
– -Item 1- bolt (2x), tightening torque 8 Nm.
– Unplug connector -item 3-.
Installing
– Installation is carried out in the reverse sequence.
5.5 Removing and installing brake pressure
sender -G201-
Removing
Note
Cover the engine compartment to ensure that no brake fluid flows
into it.
– Remove hexagon bolt - 1 - securing fluid reservoir and pull
fluid reservoir to the side and out of buffer.
– Tightening torque: 6 Nm
– Unplug connector -1-.
36
Rep. gr.45 - Anti-lock brake system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.