Audi A8 2003 Workshop Manual page 75

– Select jacking mode. ⇒ Rep. gr. 43 Operation of air suspen‐
sion
– Raise the vehicle.
– Remove wheels.
Caution
On vehicles with ceramic brakes the wheel must not be allowed
to drop onto the brake disc. This would cause irreparable dam‐
age to the disc. Screw two assembly pins into the wheel bolt
holes when removing and fitting a wheel. Insert the long as‐
sembly pin into the top hole.
– Connect vehicle diagnostic, testing and information system -
VAS 505x- and diagnosis lead, 3m with voltage supply - VAS
5051/1- to 16-pin diagnostic connector of vehicle and select
parking brake with "address word" 53. When doing this, the
ignition must be off.
Note
Ignition on
♦
Release parking brake.
♦
Coding checked and rectified if necessary
♦
Event memory interrogated, indicated faults eliminated and
♦
memory erased.
Display on VAS 505x:
– Select function "53 - Parking brake".
– Select function "04 - Basic setting".
Display on VAS 505x:
♦ The prompt to enter a display group appears in display zone
-1-.
♦ Display zone -2- shows a keypad.
When installing new brake pads:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Enter "05" or "005" as "Display group number" in display zone
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
-2- via the keypad and confirm entry with "Q key" (resetting
with respect to the correctness of information in this document. Copyright by AUDI AG.
piston).
When re-installing old brake pads:
– Enter "07" or "007" as "Display group number" via the key pad
-2- and confirm entry with the "Q key". (Brake opens all the
way, the pad thickness does not have to be entered later on.)
All vehicles
Brake system - Edition 03.2013
4. Rear brakes, electronic parking brake and handbrake (EPB)
Audi A8 2003 ➤
69