Removing And Installing Vacuum Pump (4.0 Ltr. Tdi) - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
Brake system - Edition 03.2013
11.4 Removing and installing vacuum pump
(4.0 ltr. TDI)
Removing
– Carefully pull engine cover panel off four mounting studs (one
at a time) -arrows-.
– Remove cover for suspension turret (right-side); to do so, de‐
tach fasteners-1- and unscrew retainer -2-.
– Pull cover out of retainer clamps -arrows-.
Caution
Observe rules for cleanliness when working on the injection
system.
– Disconnect fuel return line -1- and fuel supply line -2- at fuel
filter.
– Unplug electrical connector -arrow- at fuel temperature sender
- G81- and move fuel lines to one side.
124
Rep. gr.47 - Brakes - hydraulics
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.