Checking Vacuum Pump For Brakes V192 - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
Brake system - Edition 03.2013
Removing
– Unplug connector -1-.
– Disconnect vacuum hose -2- from vacuum pump for brakes -
V192- .
Caution
Take care not to damage the vacuum hose. The vacuum hose
must be renewed if it is damaged.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release clip in direction of arrow and remove.
– Pull vacuum pump for brakes - V192- upwards out of bracket.
Installing
Installation is carried out in the reverse sequence.
12.3 Checking vacuum pump for brakes -
V192-
Special tools and workshop equipment required
♦ Vehicle diagnosis and service information system - VAS 505x-
Procedure
– With ignition switched off, connect vehicle diagnosis, service
and information system - VAS 505x- to diagnostic connection.
134
Rep. gr.47 - Brakes - hydraulics