Audi A8 2003 Workshop Manual page 121

– Draw off as much brake fluid as possible from brake fluid res‐
ervoir using brake filling and bleeding equipment -VAS 5234-
or extraction unit -V.A.G 1869/4- .
– Unplug connector from sender for float warning indicator -1-.
Removing body brace
– Remove bolts with washers -1- (tightening torque 45 Nm).
– Remove bolts with washers -2- (tightening torque 3 Nm).
– -Item 3- Front section of plenum chamber
– -Item 4- Suspension turret
Arrow in illustration points in direction of travel.
– Remove bolts with washers -1- (tightening torque 9 Nm).
– -Item 2- Cross piece for suspension turret
– -Item 3- Windscreen cross member
– -Item 4- Support/ connection piece at windscreen cross mem‐
ber
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
Brake system - Edition 03.2013
9. Removing and installing brake master cylinder
115