Audi A8 2003 Workshop Manual page 79

Display on VAS 505x:
♦ The prompt to enter a display group appears in display zone
-1-.
♦ Display zone -2- shows a keypad.
– Enter "06" or "006" as display group number via the keypad
-2- and confirm entry with "Q key".
– Fit wheels ⇒ Wheels and tyres; Repair group 44 .
Caution
On vehicles with ceramic brakes the wheel must not be allowed
to drop onto the brake disc. This would cause irreparable dam‐
age to the disc. Screw two assembly pins into the wheel bolt
holes when removing and fitting a wheel. Insert the long as‐
sembly pin into the top hole.
– Check brake fluid level and top up if necessary.
Note
The electronic parking brake must now be recalibrated.
Requirements
♦ Electronic parking brake must be released.
♦ Selector lever must be in position "P".
– Switch off ignition, take out ignition key and lock steering.
Recalibration will now be performed.
♦ The electronic parking brake retracts and closes again audi‐
bly.
♦ It then sets the required clearance automatically.
– Wait for this process to be completed.
Recalibration is now completed.
Then erase fault memory.
Caution
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
After installing the brake pads and before driving the vehicle,
depress brake pedal firmly several times with the vehicle sta‐
tionary, so that the brake pads are properly seated in their
normal operating position.
Caution
Before driving vehicle for the first time, make sure function of
brakes is OK.
Brake system - Edition 03.2013
4. Rear brakes, electronic parking brake and handbrake (EPB)
Audi A8 2003 ➤
73