Removing And Installing Piston For Rear Brake Caliper - Audi A8 2003 Workshop Manual

ling protective cap
9 - Protective cap
❑ Insert onto brake carrier
and guide pin
10 - Brake carrier with guide pins and protective caps
❑ Replacement carriers are supplied assembled and with sufficient grease on guide pins
❑ If protective caps or guide pins are damaged, renew using repair kit. Use grease sachet supplied to
lubricate the guide pins.
11 - Protective cap
❑ Removing and installing
❑ Push outer sealing lip onto piston
6.2 Removing and installing piston for rear
brake caliper
Applies to steel and ceramic brakes.
Special tools and workshop equipment required
⇒ page 101
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6. Rear brake calipers for electronic parking brake and handbrake (EPB)
Audi A8 2003 ➤
Brake system - Edition 03.2013
101