Audi A8 2003 Workshop Manual page 126

Audi A8 2003 ➤
Brake system - Edition 03.2013
– Unscrew securing nuts for brake master cylinder -1-.
– Carefully remove brake master cylinder from brake servo.
Installing
When installing, note the following points in particular:
♦ Before installing brake master cylinder, clean any residual
brake fluid off plenum chamber.
♦ When assembling brake master cylinder with brake servo unit,
make sure push rod is properly positioned in brake master
cylinder.
– Adjust brake light switch
– Bleed brake system
Caution
Before driving vehicle for the first time, make sure function of
brakes is OK.
120
Rep. gr.47 - Brakes - hydraulics
⇒ page 34 .
⇒ page 110 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.