Audi A8 2003 Workshop Manual page 46

Audi A8 2003 ➤
Brake system - Edition 03.2013
2 - Brake carrier
❑ Bolt to wheel bearing housing
3 - Ribbed bolt
❑ Tightening torque: 190 Nm
❑ Clean ribs if using again
❑ M14 ×1.5 x 38
4 - Bearing bush
❑ Insert into brake caliper housing
5 - Guide pin
❑ Tightening torque: 30 Nm
6 - Protective cap
❑ Take off
❑ Insert wear indicator wire in protective cap
7 - Brake disc
❑ Wear limit ⇒ page 1
❑ Always renew on both sides of axle
❑ Detach brake caliper prior to removing
❑ Lightly lubricate contact surfaces between brake disc and wheel hub with polycarbamide grease ⇒ Parts
catalogue
❑ Allocation of brake discs
8 - Wheel bolts
❑ Fitting wheels ⇒ ELSA/ Wheel/Tyre Guide
9 - Brake line connection at brake pipe
❑ Tightening torque: 12 Nm
Note
Brake line at brake pipe: 12 Nm
♦
Brake pipe in brake caliper:
♦
19 Nm
10 - Brake line
❑ Screw into brake caliper housing
❑ Screw into brake hose, counter hold on brake hose hexagon.
❑ Do not twist hose when fitting
❑ Ensure that lugs are properly seated in grooves in bracket.
11 - Brake pipe in brake caliper
❑ Tightening torque: 19 Nm
Note
Brake line at brake hose: 12 Nm
♦
Brake pipe in brake caliper:
♦
19 Nm
40
Rep. gr.46 - Brakes - mechanism
⇒ page 1
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.