Audi A8 2003 ➤
Brake system - Edition 03.2013
3.2
Hydraulic unit and brake lines
1 - Brake master cylinder and
brake servo
2 - Brake line
❑ Brake master cylinder/
primary piston circuit to
hydraulic unit
3 - Brake line
❑ Brake master cylinder/
secondary piston circuit
to hydraulic unit
4 - Brake line
❑ Hydraulic unit to front
right brake caliper
5 - Brake line
❑ Hydraulic unit to front
left brake caliper
6 - Brake line
❑ Hydraulic unit to rear left
brake caliper
7 - Brake line
❑ Hydraulic unit to rear
right brake caliper
8 - Brake pressure sender
(01435) -1- - G201-
❑ Screws onto hydraulic
unit
❑ Tightening torque: 20
Nm
❑ Removing and installing
⇒ page 36
9 - ABS hydraulic unit - N55-
with ABS control unit with EDL
- J104-
❑ Removing and installing
10 - Nut with washer
❑ Tightening torque 9 Nm
11 - Bracket for ESP
12 - Retaining clip
3.3
Removing and installing hydraulic con‐
trol unit
Special tools and workshop equipment required
24
Rep. gr.45 - Anti-lock brake system
⇒ page 24
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.