Audi A8 2003 Workshop Manual page 87

– Remove both securing bolts (Torx TX25) from actuator motor.
– Remove actuator motor.
– Remove seal with suitable tool.
Make sure you do not damage annular groove for seal and con‐
tact surface on actuator motor.
Note
Do not use tools with sharp edges.
– If necessary clean annular groove and contact surfaces. Only
use brake cleaner.
Installing
– Fit new seal.
– Back off adjuster screw on caliper slightly to facilitate installa‐
tion of actuator motor.
Note
This makes it easier to install the actuator motor.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7. Overview of components: electronic parking brake and handbrake (EPB)
Audi A8 2003 ➤
Brake system - Edition 03.2013
81