Audi A8 2003 Workshop Manual page 81

♦ -T10159- Release tool
– Remove driver's footwell cover ⇒ Rep. gr. 68 ; General body
repairs, interior .
– Remove brake light switch
– First press brake pedal in direction of brake servo and hold.
1 - Brake pedal
2 - Push rod
3 - Retaining lugs
– Insert special tool -T10159- and pull in direction of driver seat.
When doing this, counter-hold on brake pedal. (At this moment
the pedal must not be allowed to move backwards). This will
press the retaining lugs -3- of the mounting off the ball head
of the push rod -2-.
For illustration purposes, the method of separating the brake ped‐
al from the brake servo is shown with the pedal cluster removed.
Attaching brake pedal to brake servo
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Hold ball head of push rod in front of mounting and push brake
pedal in direction of brake servo, so that the ball head audibly
locks into place.
Remaining installation steps are carried out in reverse sequence.
– Adjust brake light switch
Caution
Before driving vehicle for the first time, make sure function of
brakes is OK.
⇒ page 34 .
⇒ page 34 .
Audi A8 2003 ➤
Brake system - Edition 03.2013
5. Brake pedal (LHD) - exploded view
75