Audi A8 2003 Workshop Manual page 125

– Unscrew securing bolt -1- for brake fluid reservoir.
Note
Protect the plenum chamber against any brake fluid which es‐
♦
capes.
The underside of the brake fluid reservoir clips into the brake
♦
master cylinder.
– To remove reservoir, press down locking lug and at the same
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
time pull brake fluid reservoir out of sealing plugs.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull off brake fluid reservoir and lay it to one side.
– Disconnect brake lines -2- and seal with sealing plugs from
repair kit, Part No. 1H0 698 311 A.
– Removing and installing brake light switch
– Separate brake pedal from brake servo
– Unscrew securing bolts for brake servo -1-.
– Remove brake servo with brake master cylinder.
⇒ page 34 .
⇒ page 74 .
Audi A8 2003 ➤
Brake system - Edition 03.2013
10. Removing and installing brake servo
119