Audi A8 2003 ➤
Brake system - Edition 03.2013
3
Ceramic front brakes (PR 1LW)
⇒ "3.1 Servicing ceramic brakes", page 54
3.1
Servicing ceramic brakes
The ceramic brake discs must always be checked for damage and
wear when renewing the brake pads.
♦
⇒ "2 Assessment of ceramic brake discs", page 4
♦
⇒ "3 Assessing degree of wear on ceramic brake discs", page
7
Note
Always install all parts supplied in repair kit.
♦
After renewing brake pads, depress brake pedal firmly several
♦
times with vehicle stationary so that the pads are properly
seated in their normal operating position.
To draw off brake fluid from brake fluid reservoir use a bleeder
♦
bottle which is used only for brake fluid. Brake fluid is poison‐
ous and must NOT be drawn off by sucking through a hose.
1 - Bolts
Caution
Do NOT loosen these
bolts.
Note
These bolts do not have to be loos‐
ened in order to remove the brake
caliper. Loosen bolts -10- to remove
the brake caliper.
2 - Retaining spring for brake
pads
3 - Guide pin
4 - Brake caliper
❑ If assembly work is re‐
quired, do not leave cal‐
iper hanging from brake
hose but secure it to
body with wire
❑ With the exception of
"Renewing brake pads"
⇒ page 48
and "Servic‐
ing front brake caliper"
⇒ page 88
, no repairs
may be performed on
the brake caliper.
❑ Always renew on both
sides of axle
❑ Allocation
⇒ page 1
Brakes
❑ Removing and installing
54
Rep. gr.46 - Brakes - mechanism
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
,