Audi A8 2003 Workshop Manual page 50

Audi A8 2003 ➤
Brake system - Edition 03.2013
– Fit outer brake pad -2- in brake caliper.
Note
Fit brake pads into brake caliper and install assembly on brake
♦
carrier / brake disc.
♦
– Secure brake caliper housing to brake carrier with both guide
pins (tighten to 30 Nm).
– Make sure not to twist the brake hose when installing.
– Fit both caps.
– Insert retaining spring into brake caliper housing.
– Attach brake line
– Connect wear indicator connector and insert wire in dust cap
and protective cap.
– Fit wheels ⇒ ELSA/ Wheel/Tyre Guide ⇒ Rep. gr. 44 .
Note
The retaining spring must be pushed under the brake carrier after
engaging onto both studs. If incorrectly installed, the wear of the
outer pad cannot be adjusted, and the pedal travel will be in‐
creased as a result.
Caution
After installing the brake pads and before driving the vehicle,
depress brake pedal firmly several times with the vehicle sta‐
tionary, so that the brake pads are properly seated in their
normal operating position.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Check brake fluid level and top up if necessary.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Caution
Before driving vehicle for the first time, make sure function of
brakes is OK.
44
Rep. gr.46 - Brakes - mechanism