Audi A8 2003 ➤
Brake system - Edition 03.2013
2
Brake calipers FNR -G60-
2.1
Servicing brake calipers
Note
Install complete repair kit when servicing.
♦
Apply a thin coat of assembly paste - G 052 150 A2- to brake
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
cylinder, piston and seal.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Brake carrier
❑ Bolt to brake caliper
housing
2 - Guide pin
❑ Tightening torque: 30
Nm
3 - Caps
❑ Insert into bearing bush
4 - Protective cap
❑ Push onto bleeder valve
5 - Bleeder valve
❑ Tightening torque: 15
Nm
❑ Before screwing in,
grease thread lightly
with lithium grease ⇒
Parts catalogue .
6 - Bearing bush
❑ Insert into brake caliper
housing
7 - Brake caliper
8 - Retaining spring
❑ Note correct installation
position.
❑ Engage onto both brake
caliper housing studs
and onto outer pad re‐
taining spring.
9 - Protective cap
❑ Do not damage when in‐
serting piston
❑ Grease with assembly paste ⇒ Parts catalogue
10 - Piston
❑ Apply a thin coat of assembly paste to piston before inserting
❑ Allocation
⇒ page 1
11 - Seal
❑ Grease with assembly paste
84
Rep. gr.47 - Brakes - hydraulics