Overview Of Components: Electronic Parking Brake And Handbrake (Epb) - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
Brake system - Edition 03.2013
7 Overview of components: electronic parking brake and handbrake
(EPB)
1 - Parking brake switch
❑ Pull switch to apply
brake
❑ Push switch ⇒ to re‐
lease brake
❑ Fitting location: in centre
console
❑ Removing and installing
⇒ page 36
2 - LED indicator for applied
parking brake (light-emitting
diode)
3 - EPB system fault warning
lamp (yellow)
4 - Indication of achieved
clamping force and dynamic
deceleration
5 - Electronic parking brake
with rear left actuator motor
❑ Removing and installing
⇒ page 100
❑ Removing and installing
control unit for electron‐
ic parking brake and
handbrake ⇒ page 79
❑ Removing and installing
actuator motor for elec‐
tronic parking brake and
handbrake ⇒ page 79
6 - EPB control unit
❑ Control unit for electro‐
mechanical parking
brake (EPB) J540
❑ Fitting location: below
battery in rear right side panel
❑ Removing and installing
7 - Electronic parking brake with rear left actuator motor
❑ Removing and installing
8 - Acoustic signal
❑ Warning signal if parking brake is operated while vehicle is in motion
❑ Warning signal if a fault is detected in the system
78
Rep. gr.46 - Brakes - mechanism
⇒ page 79
⇒ page 101
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.