Renewing Front Brake Disc (Ceramic Brakes) - Audi A8 2003 Workshop Manual

– Remove locating bolt -6- from brake disc, holding brake disc
in position.
– Take brake disc off wheel hub.
Note
Take care to keep the brake disc straight when taking it off the
wheel hub.
Installing
– Clean contact surfaces of wheel hub and brake disc and re‐
move corrosion.
– Fit brake disc onto wheel hub.
Note
Take care to keep the brake disc straight when fitting it onto the
wheel hub.
– Screw in locating bolt -6- and tighten to 5 Nm.
– Attach brake caliper
– Fit wheels.
Tightening torque for wheel bolts ⇒ Rep. gr. 44
Caution
Before driving vehicle for the first time, make sure function of
brakes is OK.
3.6 Renewing front brake disc (ceramic
brakes)
WARNING
The brake disc ring and the brake disc hub are bolted together
and must NOT be separated. Do NOT slacken the bolted con‐
nection on the brake disc hub.
Note
Always renew on both sides of axle.
Removing
– Raise vehicle.
– Remove wheels.
⇒ page 60 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Brake system - Edition 03.2013
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
3. Ceramic front brakes (PR 1LW)
63