Esc [F2]+[0B]+[01]+[N] Reload Paper - Hengstler eXtendo X-56 Reference Manual

®
eXtendo Emulation Command Set Reference
2.1.61 ESC [F2]+[0B]+[01]+[n]
[Name] Reload Paper command
[Function] This command causes paper which has been unloaded in an X-56 Feed printer to
be reloaded so that the printer is ready to print.
16
[Code] [1B]
10
[27]
[Description]
1. NOTE: This command is used only by the X-56 Feed family of printers and is ignored on all
other versions.
2. The "ESC [F2]+[0B]+[01]+[n]" command is used to cause paper which has been unloaded in an
X-56 Feed printer to be reloaded so that the printer is ready to print.
3. The value "[n]" sets the Reload speed in mm/sec, and has a range of [0]
value may vary, an initial value of [46]
4. The "Unload Paper" command "ESC [F2]+[0A]+[02]+[n]+[m]" is used to unload the paper from
under the thermal printhead.
Part No. D 684 112
16 16
+ [F2] + [0B] + [01]
10 10
+ [242] + [11] + [01]
16
is recommended.
Mod.Nr. 4 150813 LEV
Reload Paper
16
+ [n]
10
+ [n]
16
to [FF]
16
. While this
Page 81 of 95