Table of Contents
Advertisement
®
eXtendo
Emulation Command Set Reference
2.1.45
FS r+[n]
[Name]
Set status parameter
[Function]
This command specifies a character which will be sent back to the host as part of
the status information.
[Code]
[1C]
16
[28]
10
[Description]
1.
The "FS r+[n]" command is used to transmit a status parameter to the printer, which is sent back
as part of the response to a "Request printer status" command ("GS a+[01]
2.
This status parameter is specified by parameter [n].
3.
The initial value for parameter [n] is [0]
4.
The range of values for parameter [n] is [0]
5.
As soon as the status parameter is transmitted back to the host in response to the "Request
printer status" command ("GS a+[01]
6.
This parameter can also be transmitted using the End of Page command.
7.
Typically, this command is used at the end of a print job to verify that the printout has been
completed successfully. First, FS r+[n} is sent to set the status parameter, then GS a+[01]
used to generate a printer status packet response. If the value of the returned status parameter
matches [n], then the print job has been successfully completed. If not, then the print job has
been lost.
8.
It is also common to increment the value of [n] with each print job so that the host can identify
which print job was lost.
Part No. D 684 112
+ [72]
+ [n]
16
+ [114]
+ [n]
10
10
.
10
≤ [n] ≤ [255]
16
"), the value of the status parameter is reset to [0]
Mod.Nr. 4 150813 LEV
Set status parameter
16
").
10
.
10
.
16
is
Page 64 of 95
- Quick Links:
- 2.1 Emulation Command Set
Hide quick links:
Advertisement
Table of Contents
