Hengstler eXtendo X-56 Reference Manual page 63

®
eXtendo Emulation Command Set Reference
Reserved
4. There may be a delay between reception of the GS a+[n] command and the transmission of the
status information.
5. A temperature alert will occur when print head temperature exceeds 70°C. In this case no printing
should be done until the printhead temperature drops below 70° C. If a printout is initiated when
the printhead temperature is above 70° C, there could be serious damage to the printer.
6. Customer flags are specified with the customer flags setting command.
Part No. D 684 112
7 Sensor active
8 Sensor inactive
4 Reserved; will read out as "0". Note that these are four 8-bit,
unsigned characters.
Mod.Nr. 4 150813 LEV Page 63 of 95