Table of Contents
Advertisement
®
eXtendo
Emulation Command Set Reference
2.1.58
ESC [F0]+[05]+[01]+[n]
[Name]
Set print density
[Function]
This command allows adjustment of the print density by changing the burn time (on
time) of the thermal printhead.
16
[Code]
[1B]
10
[27]
[Description]
1.
The "ESC [F0]+[04]+[01]+[n]" command allows adjustment of the print density by changing the
burn time (on time) of the thermal printhead.
2.
The parameter [n] specifies the amount of adjustment to the burn time that will be implemented.
Please note the following regarding [n].
a. The value of [n] is a two's complement number, representing both positive and
negative numbers.
b. The range of [n] is -100% to +100%. This number represents the percentage of the
maximum adjustment possible. The maximum adjustment is 250 µs, so the
adjustment range is from -250 µs to +250 µs.
c. The actual range of [n] is then [9C]
10
([0]
to [+100]
3.
Please note that other factors, (dot history compensation, voltage compensation, etc.), also
impact total burn time.
4.
Please note that excessively long burn times have a negative impact on thermal printhead life.
Therefore, values of [n] should be kept to the minimum possible to achieve the desired print
results.
Part No. D 684 112
16
16
+ [F0]
+ [05]
+ [01]
10
10
+ [240]
+ [05]
+ [01]
16
10
).
Mod.Nr. 4 150813 LEV
Set print density
16
+ [n]
10
+ [n]
16
10
10
to [FF]
([-100]
to [-1]
) and [00]
16
16
to [64]
Page 78 of 95
- Quick Links:
- 2.1 Emulation Command Set
Hide quick links:
Advertisement
Table of Contents
